D
DC power input and output connectors
Use the included DC (direct current) power cords to connect
the DC power input connectors of the main unit with the DC
power output connectors of the power unit .
DC OUT L e DC IN L
DC OUT R e DC IN R
o The DC power connection cords have arrows printed on
them . Connect them so that the arrows point in the direc-
tion shown in the illustration on page 12 .
Check the orientation of the pins and the arrows of each
DC power connection cord and hold it by its plug . Align the
marks on the plug and the connector and push it in com-
pletely until it clicks into place . When disconnecting, hold
the ring and pull it directly out . When unplugging, do not
pull the plug at an angle or rock it .
o Be sure that the units are off before connecting or discon-
necting a DC power connection cord .
o Be careful not to pinch your fingers in the ring when con-
necting or disconnecting a DC power connection cord .
V Never connect this to a P-0, P-01 or P1 unit. Doing so could
cause damage.
Connector
Align the marks when
connecting .
When disconnecting,
hold the ring and pull it
directly out .
Plug
E
LED brightness adjustment knob
Turn to adjust the brightness of the power indicator .
F
Power inlets
Connect the included power cords to these sockets . After com-
pleting all other connections, plug the power plugs into power
outlets .
V Use only a genuine Esoteric power cord. Use of other
power cords could result in fire or electric shock.
Disconnect the power plugs from the outlets if you will
not use the unit for a long time.
13