Left And Right Balance Setting; Output Level Setting; Phase Inversion Setting - Esoteric Grandioso C1 Manual Del Usuario

Balance and output level settings (continued)

Left and right balance setting

Bal>***
Adjust the balance between the left and right output channels .
You can set this to values between L 6 . 0 dB and R 6 . 0 dB in 0 . 5 dB
increments . You can also set this so that just one channel is muted .
The default value is 0 . 0 dB (no balance adjustment) .
Muting just one channel
Press the k button to select "Bal>R only" to output only the right
channel .
Likewise, press the j button to select "Bal>L only" to output only
the left channel .

Output level setting

Level>***
You can adjust the output level for the selected input .
You can set this to values between −18 . 0 dB and +18 . 0 dB in 0 . 5 dB
increments .
The default value is 0 . 0 dB .
o If the total of the output level and volume settings exceed 0 dB,
the output level indication will blink .
Lower the output level or volume until it stops blinking .
Note about these settings and sound quality
The left-right balance and output level settings are related to the
volume . This unit's microcomputer analyzes these settings and
the volume level value comprehensively to conduct unified con-
trol of volume amplification .
For this reason, unlike ordinary amplifiers that pass audio signals
through multiple circuits, these settings will not degrade the
audio quality .
20

Phase inversion setting

Invert>***
This can be used to reverse the phase of the audio signal output .
For example, if the XLR output of a device that sends a signal to this
unit's input is 2 HOT, but the XLR input of the device that receives
the signal output from this device is 3 HOT, set this to ON .
By default, this is set to "OFF" .
OFF
No phase inversion
ON
Phase inversion enabled
o When the phase is inverted, "INVERT" appears at the top of the
display .