Routine Cleaning; Disposal; Technical Data - Walther PILOT PREMIUM Instrucciones De Servicio

4. Apply a thin layer of grease to the following parts:
• Material needle
• Needle spring
• all sliding parts and bearing points
• The movable inside parts need to be lubricated at least once a week.
• The springs should always be coated with a thin grease film.
Use WALTHER PILOT gun grease and a brush for this purpose. The spray gun must
subsequently be reassembled in reverse order.
9.2

Routine cleaning

When changing materials or after completing work you can clean the spray gun also
without having to take it apart.
Perform the following work steps to be able to conduct the routine cleaning.
1. Fill the cleaned flow cup or the cleaned material pressure tank with a cleaning
agent appropriate for the sprayed material.
2. Start the operation of the spray gun, (see 5.2 Start-up).
3. Shut down the spray gun only after it merely sprays clear cleaning agent.
The entire spray unit must now be depressurized until the next use.
10

Disposal

Spray media as well as materials used during cleaning and maintenance shall be
properly disposed of in compliance with laws and regulations.
Warning
Follow the information of the spray and cleaning agent manufacturer. Carelessly
disposed of material puts the health of persons and animals at risk.
40
11

Technical Data

PILOT PREMIUM
Net weight:
Connections:
Atomizing Air
Material Inlet
Pressure ranges:
max. intake air pressure
max. material pressure
max. operating temperature:
Sound level
(measured at approx. 1 m
distance from the spray gun):
PILOT PREMIUM-HVLP / -HVLP
PLUS
Net weight:
Connections:
Atomizing Air
Material Inlet
Pressure ranges, medium pressure:
max. spraying pressure
max. intake air pressure
max. material pressure
Pressure ranges, low pressure:
max. spraying pressure
max. intake air pressure
max. operating temperature:
Sound level
(measured at approx. 1 m
distance from the spray gun):
Air Consumption:
Air head
Premium FB 1038
Premium FB HVLP 1060
PLUS
Premium FB HVLP
1061
Premium FA 1031
Premium FA HVLP 1160
PLUS
Premium FA HVLP 1161
Subject to technical alterations.
41
490 g Material connection
455 g Gravity-Feed Cup
G 1/4"
G 3/8"
8 bar
8 bar
43 °C
85 dB(A)
490 g Material connection
455 g Gravity-Feed Cup
G 1/4"
G 3/8"
1.4 bar
3.3 bar
8 bar
0.7 bar
3,5 bar
43 °C
83 dB(A)
Intake air pressure of Air Consumptions
the spray gun
4,0 bar 350 L/min.
3,4 bar 290 L/min.
3,5 bar 340 L/min.
4,0 bar 360 L/min.
3,4 bar 290 L/min.
3,5 bar 340 L/min.