Vortice VORT PENTA HCS Manual De Instrucciones página 8

ENGLISH
etc.).
• Do not sit on or leave objects on the appliance.
This appliance can be used by
•
children no less than 8 years of
age and by individuals with
limited physical, sensory or
mental capacities,
inexperienced
individuals, provided that they
are supervised or have been
instructed in safe use of the
appliance and understand the
associated risks. Children must
not play with the appliance.
Cleaning and
procedures
undertaken by the user must not
be entrusted to children, unless
under supervision.
The appliance must be installed
•
by a professionally qualified
electrician.
The electrical system to which
•
the product is connected must
be in compliance
applicable regulations.
Caution:
!
this symbol indicates that care must
be taken to avoid damaging the appliance
• Do not make modifications of any kind to this
appliance.
• Do not expose this appliance to the weather (rain,
sun, etc.).
• Regularly inspect the appliance for visible defects.
If any faults are found, do not operate the appliance;
contact Vortice immediately.
• If the appliance does not function correctly or
develops a fault, contact Vortice immediately.
Ensure that only genuine original Vortice spares
are used for any repairs.
• Should the appliance be dropped or suffer a heavy
blow, have it checked immediately by Vortice.
• The appliance must be installed by professionally
qualified personnel.
• The electrical system to which the appliance is
connected must conform to applicable standards.
• The appliance is double insulated and therefore
does not need to be earthed.
• The electrical power supply/socket to which the
appliance is to be connected must be able to
provide the maximum electrical power required by
the appliance. If it cannot do so, arrange for a
qualified electrician to make the necessary
modifications.
• A multi-pole switch must be used to install the
appliance. The gap between the switch contacts
8
or
or untrained
maintenance
that can
with
must be no less than 3 mm.
• Switch off the system's main switch:
appliance does not function correctly; b) before
cleaning the inside and outside of the appliance;
c) if you decide not to use the appliance for any
length of time.
• Maintenance/Cleaning: On a yearly basis, have
professionally qualified personnel check the level of
by
grime that has accumulated. If necessary, use a dry
cloth or a brush to clean the control components
and fan blades. Water should only be used to clean
the adjustment vents. Do not immerse the
appliance in water or other liquids.
• Check that the air intake section, situated towards
the outside, is clear.
• The flow of air or fumes to be carried outside must
be clean (that is free of grease, soot, chemical and
corrosive agents, and explosive or flammable
mixtures).
• The appliance must not be used to activate water
be
heaters, room heaters, etc. and it must not
discharge into the hot air ducts of such appliances.
• Keep the appliance's intake and outlet grilles free to
ensure an optimum flow of air.
• Specifications for the power supply must correspond
to the electrical data on data plate A (fig.3).
An omnipolar switch with a
•
contact opening distance of 3
mm or
provided
enabling
disconnection
overvoltage
conditions.
Products equipped with three-
phase
ALWAYS require connection to
380-415V (or only 400V where
required) threephase lines, or
also 220-240V (or only 230V
where required). Any kind of
modification shall be considered
as product tampering and shall
nullify the relative warranty.
Products equipped with single-
phase
ALWAYS require connection to
220-240V (or only 230V where
required) single-phase lines. Any
kind of modification shall be
considered
tampering and shall nullify the
relative warranty.
higher should
for installation,
complete
category
wiring (T)
wiring (M)
as
a) if the
be
under
III
engines
engines
product