Rupes SLP41A Instrucciones De Uso página 9

PARTS OF THE TOOL
1 - Identification plate
2 - On/off switch
3 - Speed control
4 - Tool body
5 - Compressed air connection with 1/4" thread
6 - Suction tube connection int. Ø 29 mm
7 - Suction control
8 - Velcro plate abrasive paper 400 x 70 mm (SLP41A)
9 - Auxiliary handle
10 - Velcro plate abrasive paper 225 x 115 mm (SO210AP)
STARTING UP
Before starting-up the tool, ensure that:
- the packaging is complete and does not show signs of having
been damaged during storage or transport;
- the tool is complete; check that the number and type of
components comply with that reported in this instruction
booklet;
- the available compressed air production and distribution plant is
capable of satisfying the requirements reported on the tool's
identification plate reproduced and explained on page 11.
ASSEMBLING THE TOOL
Assemble the compressed air connection (not supplied) by
screwing it into its seating (5).
COMPRESSED AIR CONNECTION
The tool is supplied without the compressed air connection; the
user can use either a quick release coupling or hose type con-
nection according to his needs purke that have an hole air pas-
sing mm 8. In the latter case the air line must be fixed to the nozz-
le by a hose clip.
FITTING ABRASIVE PAPER SHEETS
Press the abrasive paper sheet into the plate ensuring that the ho-
les in the paper coincided with extraction holes.
BEFORE STARTING THE TOOL
Ensure that:
- the compressed air feed line and connection are in perfect
working order;
- the start switch (2) is working properly. This must be done with
the air supply switched off;
- all the components of the tool are mounted correctly and do not
show any signs of damage.
STARTING AND STOPPING
- Starting: rotate knob (2) in the direction indicated by the arrow.
- Stopping: release the knob.
TEST RUN
Start the tool and check that there are no unusual vibration.
Otherwise switch-off the tool immediately and eliminate the
cause.
SELECTING THE RPM
The rpm can be adjusted by rotating the knob (3). The choice of
speed depends on the characteristics of the abrasive paper
sheets and the material to be worked.
9