Troubleshooting Chart - Air Liquide Respireo SOFT Child Manual De Uso

The mask can be regenerated up to 12 times, using one of the
following methods:
• high-level thermal disinfection;
• high-level chemical disinfection;
• sterilisation in an autoclave at 121°C for no more than 20
minutes;
Full details of the mask regeneration process can be obtained
by logging on to www.device.airliquidehealthcare.com or by
contacting your dealer.
9 - PRECAUTIONS
Do not clean the mask with solutions containing alcohol, aromatic
compounds, humidifiers, antibacterial agents or aromatic oils as
they would damage the product and reduce its life.
Prolonged exposure to direct sunlight or heat may damage
the mask.
If any damage is noticed (cracks, tears, etc.), the damaged
part must be replaced.
Check carefully to make sure there are no soap deposits or
foreign bodies inside the mask.
10 - PRESSURE/OXYGEN PORT
If additional oxygen or a pressure reading is required, use the
port in the elbow fitting (3).
Remove the cap (6) and insert the oxygen/pressure tube in the port.
ENGLISH
11 - TROUBLE-SHOOTING CHART
PROBLEMS POSSIBLE CAUSES SOLUTIONS
• No air or • Flow generator off
insufficient
air comes • Flow generator
out of the
mask • Patient tube not
• The mask is • Mask assembled
noisy
• The mask • Mask not positioned
does not
fit the face
snugly
• Headgear straps
12 - DISPOSAL INSTRUCTIONS
The components of the mask are made of the following
materials and must be disposed of in accordance with the
applicable laws.
COMPONENT
Main body (a)
Tube assembly (b)
Headgear assembly (c) Nylon + polyurethane
13
• Switch on the flow
generator.
• Regulate the flow
regulated wrongly generator.
• Connect the patient
connected tube to the flow
generator and mask.
• Take the mask apart
incorrectly and reassemble it, as
explained in section
HOW TO ASSEMBLE
THE MASK.
• Reposition the mask,
correctly on the as explained in
patient's face section HOW TO PUT
THE MASK ON THE
CHILD.
• Unfasten the lower
too tight straps and refasten
more loosely.
MATERIAL
Silicone + Polycarbonate
Polycarbonate + Metallocene +
Acetalic + Silicone