Dea ADVANCE Instrucciones De Uso página 31

7.2 Uploading data from an external memory unit (UPLOAD)
1. Scroll down the parameters with
2. Press the key, the display visualizes the word "
3. Press the again and continue pressing for 5 sec (if you release it before this period, the procedure is stopped);
4. Release the key as soon as the word "
All the control panel confi gurations (TYPE, parameters, remotes, operators stroke, etc..) contained in the external memory unit are
uploaded in the connected control panel;
5. At the end of the operation display returns to P012.
WARNING If you are not connected to any MEMONET units or if the connecting cable is disconnected during the data transfer operation,
the display will visualize
Refer to the MEMONET instruction to restore command unit functioning.
8 Inputs confi guration
Where the installation requires different commands and / or additional to
the standard ones described by plan, you can confi gure each input for the
operation desired (eg. START, PHOTOS, STOP, etc ...).
1. Scroll down the parameters with the
to the desired one:
● P018=for INPUT 1;
● P019=for INPUT 2;
2. Confi rm by pressing on the
P018);
3. Scroll down with the and
the desired operation (refer to table "Input Confi guration parameters" on
page 32);
4. Confi rm by pressing on the
5. Execute the new connection to the input just reconfi gured.
9 Programming complete
WARNING At the end of the programming procedure, re-introduce Jumper J4, until "- - - -" is shown on the display and close the lid of
the electric box. The automatism is now in stand-by for normal operating commands.
and keys until you visualize P012;
" fl ashing;
" stops fl ashing;
, then the control unit is entirely reset and the display shows the word "TYPE" fl ashing.
and to see that corresponding
key to get access to the parameter (eg.
, keys to set the value corresponding to
key (display shows again P018).
29