Configuración - Programación Del Amplificador - Fermax DUOX PLUS DIRECT CITY Manual De Instalador Y Programación

Configuración - Programación del Amplificador
El amplificador DUOX PLUS se puede configurar para permitir un funcionamiento como
placa de entrada general, entrada de bloque o entrada de sub-bloque.
• El sistema DUOX PLUS emplea direcciones de terminal de vivienda de 6 dígitos.
• Los dígitos del código de llamada se organizan de la siguiente manera, BBSSNN:
- BB: indica el número de Bloque, (de 00 a 99).
- SS: indica el número de sub-bloque, (de 00 a 99).
- NN: indica el número de vivienda del sub-bloque, (de 00 a 99).
No es necesario segregar la instalación según ésta jerarquía ya que el sistema se adapta
a las necesidades de la instalación.
NOTA IMPORTANTE:
Configuración de parámetros por el instalador.
- Para programar - modificar dichos parámetros ver «Seccion II: Manual de Programación», (al final
de este manual).
3
SW1 : Programming button
• Apartment terminals programming is always done from the panel activated as MASTER.
• Any installation can only have one MASTER panel at a time, whether a single or multiple
block installation, once configured as a sub-block, block or general entrance.
• A outdoor panel is configured as a MASTER via the SW1 amplifier button. If the SW1
button is pressed 3 times quickly, it is activated as a MASTER panel and a confirmation
tone sounds (beep-beep), after 2 seconds. You can also configure it via a code on the
keypad, see Section II.
• When a panel is selected as MASTER, it notifies the rest of the situation and if another
was previously configured, it would automatically stop being so.
• If there are various blocks in an installation, we recommend using the general entrance
panel as MASTER since it allows you to program all of its telephones/monitors.
• Once having completed the terminal´s configuration, we recommend deactivating the
MASTER panel to avoid accidentally reprogramming terminals.
• The panel deactivates itself from master mode following the same activation procedure: 3
quick presses of the SW1 button. A deactivation tone sounds (bip-bop), after 2 seconds.
Configuration - Programming the Amplifier
The DUOX PLUS amplifier can be configured to allow for the operation as a general
entrance, block entrance or sub-block entrance.
• The DUOX PLUS system uses 6 digit house terminal addresses.
• These call code digits are organised as follows: BBSSNN:
- BB: indicates the Block number, (from 00 to 99).
- SS: indicates the sub-Block number, (from 00 to 99).
- NN: indicates the sub-Block house number, (from 00 to 99).
You do not have to segregate the installation according to this hierarchy since the system
adapts to the installation´s needs.
Pag 12
MASTER Panel: