Resetting The Programming Access Code (If The Previous One Is Forgotten); Configuration Of The Outdoor Panel With Buttons (With No Keypad) - Fermax DUOX PLUS DIRECT CITY Manual De Instalador Y Programación

NOTES:
- If trying to assign the same programming code as the lock-release code, it is not allowed and a call
error tone sounds (beep-bop).
-To deactivate the opening code you must enter the value AAAA in position 08
- When configuring a zero value in «Volume Monitoring" you mute the button, call, and other monitorings
of the outdoor panel.

Resetting the programming access code (if the previous one is forgotten).

En If you have changed the programming access code (if the previous one is forgotten), you
may restore the default code.
Carry out the following steps:
1. With the power supply disconnected, short circuit the «Bs» and «-» (negative) amplifier
terminals (or press the exit button when one exists).
2. Maintaining the short-circuit induced above, connect the system's power supply (at this
point it will no longer be necessary to maintain the short circuit or hold down the button).
The default code is now restored: 4444.
NOTE:
- If you happen to assign the door´s lock-release code the same code as that of the default programming
entrance code, when restoring the programming access you immediately deactivate the lock-release
access code. This is because you can not have the same code in both programming parameter fields.

Configuration of the outdoor panel with BUTTONS (with no keypad).

You can not configure the buttons panel alone, since it does not have a keypad for entering
the numeric values. For this you must temporarily connect a keypad (ref. 7439) to modify
said parameters.
Carry out the following steps:
1. With the power disconnected remove the CN1:
- in the PLACA CITYLINE the call extension module.
- in PLACA SKYLINE the skyline button panel.
2. Use the cable to connect the keypad as shown in the diagram.
3. Reconnect the power supply. Now you can program the required parameters with the
keypad (Table in previous page).
4. Before completing the keypad disconnection operations and connecting the new call
extension module or skyline button module, remove the power.
Pag 45