Assembly; To Attach The Cutting Deck - Husqvarna R 419TsX AWD Manual De Usuario

CAUTION: Read the caution instructions
that follow before you use the product.
• Do not turn over the engine if the spark plug or
ignition cable is removed.
• Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good condition.
Introduction
WARNING: Read and understand the safety
chapter before you assemble the product.

To attach the cutting deck

1. Park the product on level ground.
2. Apply the parking brake.
3. Set the lift lever for the cutting deck in transport
position.
4. Move the weight transfer lever up to disengage the
weight transfer.
5. Set the lift lever for the cutting deck in the mow
position.
6. Stop the engine.
14
• Do not change the adjustment of governors. If the
engine speed is too high, the product components
can become damaged. See
37 for highest permitted engine speed.
• The product is approved only with the equipment
supplied or recommended by the manufacturer.

Assembly

7. Set the cutting height lever to the servicing position.
8. Align the cutting deck to the equipment frame.
9. Push the cutting deck into the equipment frame
forward until it stops.
Technical data on page
880 - 006 - 09.09.2020