Assembly - Husqvarna R112iC Manual De Usuario

• The blades are sharp and can
cause cuts. Wind protection
around the blades or use
protective gloves when you
do work on the blades.
• Always put the cutting deck in
the servicing position to clean
it. Do not park the product
near the edge of a ditch or
slope to get access to the
cutting deck.
CAUTION: Read the
caution instructions that
Introduction
WARNING:
spring can break and cause injury. Wear
protective glasses when you attach or
remove the cutting deck.
Read the assembly instructions in the owner's manual
carefully. A label on the inner side of the front cover on
the product, also shows how to attach and remove the
cutting deck.
To attach the cutting deck
1. Park the product on level ground.
2. Apply the parking brake.
1263 - 006 - 27.04.2022

Assembly

The drive belt tension
follow before you use the
product.
• Make sure that all nuts and
bolts are tightened correctly
and that the equipment is in
good condition.
• Do not change the adjustment
of governors. If the motor
speed is too high, the product
components can become
damaged. Refer to
data on page 29 for highest
permitted motor speed.
• The product is approved only
with the equipment supplied
or recommended by the
manufacturer.
3. Push the cutting deck in and make sure that the
bolts are put into the grooves on the equipment
frame.
Technical
15