Assembly; To Remove The Product From The Carton - Husqvarna TS 354XD Manual De Usuario

the maintenance schedule. Refer to
schedule on page 19 .
• Electrical shocks can cause injuries. Do not
touch the cables when the engine is on. Do not
do a function test on the ignition system with your
fingers.
• Do not start the engine if the protective covers
are removed. There is a high risk of injury
caused by moving or hot parts.
• Let the product become cool before you do
maintenance near the engine.
• The blades are sharp and can cause cuts. Wind
protection around the blades or use protective
gloves when you do work on the blades.
• Always put the cutting deck in servicing position
to clean it. Do not park the product near the edge
of a ditch or slope to get access to the cutting
deck.
Introduction
WARNING:
the safety chapter before you assemble
the product.
To remove the product from the
carton
1. Remove loose parts included with the product.
2. Remove the end panels.
3. Remove the side panels and put them on a flat
surface.
4. Remove all package materials.
5. Remove the product from the carton and make
sure no loose parts are left in the carton.
Assembly tools
Note:
A socket wrench set will make the assembly
procedure easier.
• 1/2" (13 mm) wrench
• Tire pressure gauge
• Utility knife
• Pliers
Loose parts that need assembly
The product is not fully assembled. The parts that
follow are loose when the product is purchased.
Key, 2 pcs
Slope sheet, 1 pcs
10
Maintenance

Assembly

Read and understand
CAUTION:
instructions that follow before you use
the product.
• Do not turn over the engine if the spark plug or
ignition cable is removed.
• Make sure that all nuts and bolts are tightened
correctly and that the equipment is in good
condition.
• Do not change the adjustment of governors.
If the engine speed is too high, the product
components can become damaged.
• The product is approved only with the equipment
supplied or recommended by the manufacturer.
Hex bolt, 2 pcs
Nuts, 2 pcs
Nozzle adapter, 1 pcs
Oil drain tube, 1 pcs
Seat adjustment knob, 2 pcs
Seat adjustment bolt, 2 pcs
Seat bumper, 2 pcs
Bolt for seat bumper, 2 pcs
Read the caution
1940 - 006 - 13.09.2022