Infant Car Seat - BABYTREND JG95B Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SAFETY
TO RELEASE THE CHILD
Type 1
15) • To release, push Button on Center
Clasp, the two Harness Buckles will
pop free (Fig. 15).
Type 2
16) • To release, apply pressure to both
sides of each male clip until the clip is
released (Fig. 16).
JOGGING WITH YOUR STROLLER
WARNING:
with your newborn in the car seat
position. Use for strolling only.
STRANGULATION
HAZARD!
strangled when straps have wrapped
around their neck. Remove strap when
not in use and place in stroller storage
pocket. Keep this stroller carrier strap
out of children reach.
When you are jogging with your child, use the
following safety features:
17) • LOCK THE FRONT SWIVEL WHEEL IN
STRAIGHT POSITION (Step 13).
• SAFETY WRIST STRAP: Always connect
the safety strap to either wrist when
jogging. This strap will keep the stroller
from rolling away in the event that you trip
while running (Fig. 17a). The safety strap
must remain connected to the rear lower
frame cross member at all times. This
11
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.
TYPE 1
Center Clasp
TYPE 2
Never jog or run
Children have
location is intended to prevent the stroller
being tipped backward in the event that
you do fall to the ground. The safety strap
includes a hook and loop attachment for
storage, on the left side of the stroller,
when not in use (Fig. 17b).
Fig. 15
INFANT CAR SEAT ATTACHMENT
WARNING:
jog or run with your newborn
in the car seat position. Use
for strolling only.
Fig. 16
WARNING:
serious injury from falling
or sliding out, always use
the Infant Car Seat harness.
18) • Fully recline seat back and turn car seat
Support Tabs on the stroller frame
(Fig 18a).
NOTE: Car Seat Support Tabs are Only
used for the infant car seat. Check that
the front child tray is firmly attached to
the stroller armrests.
• Position the infant car seat so that it
faces toward the rear of the stroller and
the seat shell goes into the front tray
and latches into place (Fig. 18b).
• When the infant car seat is locked firmly
into place, strap the single Short Clip
over the infant car seat through the seat
belt slot on the infant car seat (Fig. 18c).
NOTE: It is very important that the Short
Clip is always tightly fastened around
the infant car seat.
Fig. 17a
Copyright © 2018, Baby Trend Inc., All Rights Reserved. Todos los derechos reservados. Tous droits réservés.

INFANT CAR SEAT

Never
Avoid
Fig. 17b
Fig. 18a
Fig. 18b
Short clip
Fig. 18c
12

Publicidad

Tabla de contenido
loading

Tabla de contenido