Power Supply Installation - Fermax Citymax 1/L Manual De Usuario

POWER SUPPLY INSTALLATION

Finally, the Power Supply must be placed in a place dry and safe from the
weather. Its DIN 10 format allows you to install it in any type box or directly on the
wall by using the wallplugs and screws supplied.
1. Drill 2 holes in the wall, place the
wallplugs and fasten the screws, fixing
the Power Supply to the wall.
3. The Power Supply can be unmounted
from the DIN rail by levering at the
flange with a flat screw-driver.
NOTE:
The Power Supply must be installed in a place dry and safe from
inclemency of weather. It is advisable to install it protected through a
thermo-magnetic circuit breaker at the main input.
KIT VIDEOCHALET CITYMAX Cod: 94017
2. The Power Supply can be fitted on a
DIN rail inside a box pressing it as
shown in figure.
4.Plug-in the wires in the corresponding
terminals following the installation
diagrams attached.
Pag 23