Steps For Installation; Power Supply Installation - Fermax HALO & iLOFT Manual

Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft
Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft Kit Halo & iLoft

STEPS FOR INSTALLATION

1. Install the Kit equipment as shown in this manual.
2. Connect the system to the power supply.
3. Program the video door entry monitor.
See section: «Programming the monitor».
4. Program the access control function: activate the proximity cards.
See section: «Panel configuration».
5. Adjust the entry panel and home monitor as required: adjust the opening times,
brightness, colour, etc..
See sections:
- «Panel settings».
- «Panel configuration».
- «Monitor Settings».

POWER SUPPLY INSTALLATION

DIN rail installation
Assembly
NOTES:
POWER SUPPLY (LEDs)
ON
On LED
On + OVERLOAD LED blinking indicates short circuit.
Pag 8
All manuals and user guides at all-guides.com
Dismantling
Maxium current exceeded LED indicator.
Fixng with screw bolts
OVERLOAD