Checking The Chain Brake - Makita XBU02 Manual De Instrucciones

NOTE:
Boost mode up to 60 seconds. Depending on
the usage conditions, this mode shifts to the
normal mode in less than 60 seconds.
NOTE: If the mode indicator blinks in green
when you press the main power switch for a
available. In this case, follow the steps below.
right after the cutting operation. Wait for
more than 10 seconds, and then press
the main power switch for a few seconds
again.
is restricted to protect the battery. If the
waiting for more than 10 seconds, replace
the battery cartridge with a fully charged
one, or recharge the battery cartridge.
NOTE: If the main power lamp lights up in red
or blinks in red or green, refer to the instruc-
tions for tool/battery protection system.
Switch action
WARNING: For your safety, this tool is
the tool from unintended starting. NEVER
use the tool if it runs when you simply
pull the switch trigger without pressing
the lock-off lever. Return the tool to our
authorized service center for proper repairs
BEFORE further usage.
WARNING: NEVER tape down or defeat
purpose and function of lock-off lever.
CAUTION: Before installing the battery
cartridge into the tool, always check to see
that the switch trigger actuates properly
and returns to the "OFF" position when
released.
NOTICE: Do not pull the switch trigger hard
without pressing the lock-off lever. This can
cause switch breakage.
start the tool, depress the lock-off lever and pull
by increasing pressure on the switch trigger.
Release the switch trigger to stop.
1
1. Switch trigger 2. Lock-off lever

Checking the chain brake

CAUTION: Hold the chain saw with both
hands when switching it on. Hold the top
handle with your right hand, the front han-
dle with your left. The bar and the chain
must not be in contact with any object.
CAUTION: Should the saw chain not
stop immediately when this test is per-
formed, the saw may not be used under
any circumstances. Consult our authorized
service center.
1. Press the lock-off lever, then pull the switch
12
ENGLISH
-
2