Checking The Spark Plug; Cleaning Procedure - Makita EB5300TH Manual De Instrucciones Original

Sopladora a gasolina
Ocultar thumbs Ver también para EB5300TH:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 116
► 1. Upper limit mark 2. Lower limit mark
8.
After filling with oil, tighten the oil cap securely to
prevent oil leaks.
NOTICE:
Do not forget to put the oil cap gasket
back on when reattaching the oil cap.
Cleaning of air cleaner
WARNING:
INFLAMMABLES STRICTLY
PROHIBITED
Interval of Cleaning and Inspection
Daily (every 10 operating hours)

Cleaning procedure

2
1
► 1. Knob bolts 2. Air cleaner cover 3. Element
4. Breather
1.
Loosen the knob bolts.
2.
Remove the air cleaner cover.
1
2
3
4
3.
Remove the element and clean off any dirt from
the element with a cloth or air blow. Replace the ele-
ment with a new one if it is damaged or very dirty.
NOTE: The element is a dry type and should not get
wet. Never wash with water.
4.
Wipe off any oil around the breather with a rag or
cloth.
5.
Install the element in the air cleaner case.
6.
Attach the air cleaner cover and tighten the knob
bolts.
NOTICE:
Clean the element several times a
day, if excessive dust adheres to it due to dusty
environment.
NOTICE:
If operation continues with the
element remaining not cleared of oil, oil in the
air cleaner may fall outside, resulting in oil
contamination.

Checking the spark plug

CAUTION:
while the engine is running. Otherwise electrical
shock may result.
CAUTION:
switch to OFF "O" position.
CAUTION:
larly. If it is damaged or torn, replace it. Otherwise
electrical shock may result.
NOTICE:
When removing the spark plug, clean
the spark plug and cylinder head first, so that no
dirt, sand, etc will enter the cylinder.
NOTICE:
Remove the spark plug after the
engine has cooled down in order to avoid damag-
ing the threaded hole in the cylinder.
NOTICE:
Install the spark plug properly into the
threaded hole. If installed at an angle, the threaded
hole in the cylinder will get damaged.
1.
To open the plug cover, lift it and make a half turn
of it.
1
► 1. Plug cover
2.
Use the box wrench provided as an standard
accessory to remove and install the spark plug.
17 ENGLISH
Do not touch the spark plug
Set the stop control lever/stop
Check the spark plug cord regu-

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Eb5300wh

Tabla de contenido