Fitting The Carrying Ring - Stihl KB-KW Manual De Instrucciones

Mounting the Gearbox
Remove both sweeping
N
attachments – see "Replacing the
Sweeping Attachments".
4
3
Push the sleeve (4) onto the drive
N
tube (3) as far as stop.
5
3
5
Loosen the clamp screws (5) – do
N
not remove them.
Push the gearbox (6) onto the drive
N
tube (3), turn the gearbox back and
forth as necessary.
KB, KW
Aligning the Gearbox
Line up the gearbox on the drive
N
6
tube so that the distance between
the horizontal axles (7) and the
deflector is the same at both sides.
Tighten down the clamp screws
N
firmly.
WARNING
It must not be possible to rotate the
gearbox on the drive tube.
Mount the two sweeping
N
attachments – see "Replacing the
Sweeping Attachments".

Fitting the Carrying Ring

Not all basic power tools are equipped
with a carrying ring.
The carrying ring is available as a
special accessory.
The type of carrying ring depends on the
market and the basic power tool.
1
1
2
For position of carrying ring see
"Mounting the Loop Handle".
Place the clamp (1) against the
N
drive tube with the tapped hole on
the left (viewed from engine).
Squeeze the two ends of the clamp
N
together and hold in that position.
Insert the M6x14 screw (2).
N
Line up the carrying ring.
N
Tighten down the screw firmly.
N
English
13