Scrapping The Machine - IPC Gansow 1010 S Manual De Instrucciones

Before carrying out any work on the machine,make
sure that it is off and that all its functions aredisabled.
This is done by turning the key switch (5, fig.3)OFF.
7.14 - REPLACING THE FILTER SHAKER
MOTOR VIBRATOR
To replace the filter shaker motor vibrator, proceed as follows:
1 -Lift the top bonnet.
2 -Loosen the wing nut and remove the filter box cover.
3 -Loosen the 4 filter fixing knobs.
5 -Remove the filter from its seat.
6 -Loosen the 2 power supply cable fixing screws and disconnect
the motor.
4 -Remove the 4 motor fixing screws from the filter holder and
remove the motor vibrator.
To reassemble the motor vibrator carry out these operations in
reverse order.
IMPORTANT: WHEN CONNECTING THE MOTOR,
RESPECT ITS POLARITY.

8.1 - SCRAPPING THE MACHINE

This product is classified as RAEE type special waste and
is covered by the requisites of the new environmental
protection regulations (2002/96/CE RAEE). It must be
disposed of separately from ordinary waste in compliance
with current legislation and standards.
Special waste. Do not dispose of with
ordinary waste.
DO NOT use scrap pieces as spareparts
ALSO IN THIS CASE KEEP OUT OF
THE REACH OF CHILDREN
ENGLISH (Translation of original instructions) Pag. 13