Inglesina Huggy Isofix Manual De Instrucciones página 19

INSTRUCTIONS
fig. 10 The correct hooking of the Huggy Multifix or Huggy Prime car seat occurs
when the proper indicators (G) from RED become GREEN. Make sure that the seat is
properly hooked, trying to lift it.
CAUTION: if the base Isofix connectors (D) are not duly hooked, the Inglesina
Huggy car system does not allow the correct installation of the car seat on the
base, as a consequence do not force the hooking.
fig. 11 After having hooked the Huggy Multifix or Huggy Prime car seat on the
Huggy Isofix base, press the two buttons (L) simultaneously and rotate the handle of
the seat to the most forward position. Make sure that the two buttons (L) completely
come out, after having arranged the handle to the proper position.
fig. 12 Act on the release lever (C) to release the first blocking device of the car
base. Then, push the base with the seat against the car seat until it leans completely
on the same.
fig. 13 Verify once again that the Inglesina Huggy car system is properly hooked.
REMOVAL OF THE INGLESINA HUGGY CAR SYSTEM
fig. 14 By pressing the two buttons (L) simultaneously, rotate the seat handle to
the vertical position and, by acting on the rear lever (I), lift it from the Huggy Isofix
base by holding it from the handle.
fig. 15 Shorten the car base support foot (A), acting on the proper lever (F).
fig. 16 Then, release the Isofix connectors (D) from the Isofix anchoring points (K)
on the car seat by pressing the two release buttons (H).
CAUTION: the release button (H) remain blocked until the seat remains
installed on the base.
fig. 17 Lift the base from the car seat, repositioning the support foot (A) in its
seat.
19