Simplified Eu Declaration Of Conformity - MELICONI AT38 PLUS Instrucciones De Uso

Ocultar thumbs Ver también para AT38 PLUS:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 13
C
Proceed as follows when if the image quality is unsatisfactory or no signal is received:
• Rotate and/or tilt the antenna until you achieve quality reception. (fi gure 3)
• Change the position, extension and orientation of the stylus antennas on the sides.
• Regulate the gain by adjusting the amplifi cation; highest gain level does not always correspond
to a better image quality.
• If possible, we recommend to tune the device channels (TV / DECODER)
by temporarily connecting it to a different and valid source of signal (apartment block
antenna).
It is worth remembering that the use of an internal antenna should be considered an "alternative"
solution for the reception of television channels; so, as a result of the intensity of the signals that the
antenna can achieve inside the room, more or less satisfactory results can be achieved depending
on the conditions of use.
D
Technical features and specifi cations
• Indoor amplifi ed antenna
• 230V ac - 50 Hz power supply from the mains via the adapter included in the box.
• Reception of digital terrestrial TV signals (DVB-T) and DAB and DAB+ digital radio signals.
• Reception range: VHF (174~230MHz) band III and UHF (470~790 MHz).
• 4G LTE + GSM interference proof fi lters.
• Signal fi ne tuning: up to 38dB.
• Consumption: <2 W
• Output impedance: 75 Ohm
E
- Antenna
- Instruction booklet
- AC/DC power supply
2 YEAR WARRANTY
The warranty will no longer be valid if the product is tampered with or used incorrectly. Keep your
receipt as proof of warranty.
The manufacturer, Meliconi SpA, declares that the type of radio equipment, "AT38 PLUS amplifi ed
antenna" complies with Directive 2014/53/EU (RED).
The full text of the EU Declaration of Conformity can be found at the following link:
www.meliconi.com/doc/at38plus
The crossed bin symbol on the appliance indicates that, at the end of its life cycle, the product must be disposed of
separately from other waste. So, at the end of its life cycle, the user must take the equipment to a suitable separate
waste disposal centre for electronic and electrical waste or return it to the retailer when purchasing a new appliance
of the same type, on a one for one basis. Proper separate disposal for the future use of the equipment designated
for recycling, treatment and environmentally compatible disposal helps prevent possible negative effects on the
environment and on human health and encourages recycling and/or reuse of the materials used to produce the
equipment.
4
Reception improvement
Box contents

SIMPLIFIED EU DECLARATION OF CONFORMITY

Publicidad

Tabla de contenido
loading

Tabla de contenido