Appliance Description; Initial Use; Inserting The Batteries; Care And Storage - Beurer BS 89 Instrucciones Para El Uso

Note: Disposal
For environmental reasons, do not dispose of the device in the household waste at the end of its useful life. Dis-
pose of the unit at a suitable local collection or recycling point. Dispose of the device in accordance with EC Di-
rective – WEEE (Waste Electrical and Electronic Equipment). If you have any questions, please contact the local
authorities responsible for waste disposal.
The empty, completely flat batteries must be disposed of through specially designated collection boxes, recycling points
or electronics retailers. You are legally required to dispose of the batteries.
The codes below are printed on batteries containing harmful substances:
Pb = Battery contains lead,
Cd = Battery contains cadmium,
Hg = Battery contains mercury.

3. Appliance description

1. LED illumination
2. Mirror (five times magnification)
3. On/Off button (for adjusting the light intensity)
4. Battery compartment
5. Wall bracket
6. Swivel joints

4. Initial use

4.1 Wall fastening
• Remove the wall bracket and attach it to the wall us-
ing the assembly kit provided (2 screws, 2 wall plugs).
• First mark the desired position on the wall and drill 2 holes at the appropriate intervals.
• Insert the wall plugs. Then attach the wall bracket, by screwing the screws into the wall
plugs.
• Now attach the mirror to the wall by screwing in the screw on the underneath of the wall
bracket.

4.2 Inserting the batteries

In order to use the cosmetics mirror, you first need to insert the supplied batteries. To insert
the batteries, follow the steps below:
1. Remove the battery compartment lid on the rear of the device.
2. Insert the three supplied 1.5V AA (alkaline type LR6) batteries. Make sure that the
batteries are inserted with the correct polarity, according to the label. Do not use
rechargeable batteries.
3. Close the battery compartment lid carefully.
4.3 Operation
• The light can be switched on or off using the on/off switch located on the rear of the mirror.
• The light intensity can be adjusted by pressing the on/off switch again. There are three light intensity levels to choose
from.
The light switches off automatically after 10 minutes.

5. Care and storage

• Switch off the device each time before cleaning.
• First unplug the device and allow it to cool off. Then you can clean it with a soft, slightly moistened cloth. Then
wipe it dry with a soft, lint-free cloth.
• Only clean the appliance in the manner specified. Fluid must never be allowed to enter into the device or accesso-
ries.
• Do not use the device again until it is completely dry.
• Do not clean the device in the dishwasher.
• Do not use aggressive cleaning agents or hard brushes.
1
2
8
6
2.
2
1
3
4
5
1.