Gima Domino Manual De Uso página 13

13 ENGLISH
The operation procedure for presetting Date/Time is as follows:
1.When the device is connected to power supply at first time,the display will show as Fig. 1;
2.Press button 'F', and the year number flashes;
3.Press button 'M1' or 'M2' to subtract or add the number, and press button 'START' for confirmation;
4.When the year setup is finished, the month number will flash automatically as Fig.3. Please follow the
same instruction as above to set month, date and time;
5.Press button 'START' to finish setup. If you want to change the date and time, please repeat procedure
2.3.4.
FUNCTION OF REMINDERS
Setting reminders
This monitor has 3 reminder alarms. You can set 3 different reminder alarms within a 24 hours period.
1.When the device stands by, press button 'F' two times to enter into alarm 01 mode, the display will show
as Fig.4;
2.Press button 'M1'or'M2' the display will show as Fig.5 and at the same time the hour number flashes;
3.Press button 'M1'or'M2' again to subtract or add the number, and press button 'START' for confirmation;
4.When the hour number setup is finished, the minute number will flash automatically. Please follow the
same instruction as above to set minute number;
5.Press button 'START' for confirmation.
6.When the device stands by, press button 'F' three and four times respectively to enter into alarm 02 and
03 mode. Repeat the above process if you need a second and third alarm clock.
Annotation: When the alarm is on under device stands by, the icon ' ' flashes on LCD and goes with beep
for 1 minute. Press the button 'START' to turn off the alarm.
When the alarm is on during measurement, the icon ' 'flashes on LCD for 1 minute without beep. Under
this situation, if you press the button 'START', it will stop both the icon ' 'flashing and measurement.
Reminders clearance
1.When the device stands by, press button 'F' two times to enter into alarm 01 mode, then
press button 'M1' for at least 5 seconds, the display will show as Fig.7 which means the
alarm 01 is removed.
2.When the device stands by, press button 'F' three and four times respectively to enter into
alarm 02 and 03 mode . Repeat the above process to remove the alarm 02 and alarm 03.
AMBIENT TEMPERATURE DISPLAY AND ADJUSTMENT
This monitor can display the ambient temperature and the unit °C and °F can be adjustable. °C mode
display in the LCD when the first time used.
1.When the device stands by, press button 'F' five times to enter into the temperature adjustable mode,
then press button 'M1' to turn into °F mode and press button 'START' for confirmation.