Velleman CAMCOLVC9 Manual Del Usuario página 4

• USB 2.0 plug and play device
• USB cable included
5. Operation
Recording
• Point the camera [1] towards the field of interest.
• Press and hold the control button [5] for ±3s. The status LED [4]
turns on orange to indicate that the device is ready.
• To start recording a movie, short press the control button [5].
The status LED [4] turns on blue to indicate that the device is
recording. The recorded format is AVI. Short press the control
button [5] again to stop recording (LED [4] orange). Note that
this might take a few seconds.
• To take a picture, press and hold the control button [5] for ±3s.
The status LED [4] turns on blue to indicate that the device is in
picture mode. Short press the control button [5] to take a
snapshot; the orange status LED [4] blinks when the snapshot is
taken. Note that this can take ±3s. The image format is JPG.
• To switch the device off, (when necessary) quit picture mode by
pressing the control button [5] for ±3s. Then short press the
control button [5] (status LED [4] turns blue), immediately
followed by a long press on the control button [5].
Overview:
picture mode
(blue)
[5] picture
([4] orange)
Play back
• Hold the camera part of the device and turn the pen part counter
clockwise.
• Insert the USB connector [3] into a USB port of a computer (not
incl.). When necessary, use the included USB extension cable.
• The status LED [4] will light up orange and the device will now act
as a regular USB memory stick. Copy, open or delete the
recordings as you would with other files on your computer system.
Charging
• The battery charges when the device is connected to a powered
USB port.
Reset
• When the device does not react anymore, use a small pin (e.g. a
paper clip) to gently press the reset-button [6].
08.02.2010
CAMCOLVC9
[5] (long)
ON
[5]
([4] orange)
(long)
4
OFF
[5]
recording
[5]
([4] blue)
(short)
©Velleman nv
Rev. 02
(long)