Cleaning And Maintenance - HSM SECURIO P 44 Instrucciones De Servicio

Display Problem
Oil reservoir
empty
Display Function
Button lock
is activated
Notes
Manual reversing
If you press the reverse button, the cutting unit runs
in reverse and switches off after 2 seconds, even if
you keep the button pressed. To reverse manually,
release the button and press it again.
If the shredder is already running forward, pressing
the button immediately reverses it.
Shredded material container
Both cutting units stop when the paper or CD con-
tainer is full.
On machines with a separate CD cutting unit, the
level in the CD container (see overview, item 7) is
monitored. Empty the container after there is a sig-
nal on the operating and indicator element.
Automatic oiler (cross cut only)
The cutting units are oiled for 1.5 seconds after:
• The cutting unit is in operation for 200 seconds
(corresponding to 50 paper shreds)
• The cutting unit runs forwards after the reverse
button has been pressed
The "Oil reservoir empty" signal is automatically
deactivated after the reservoir is fi lled. The shredder
remains operational even when the oil reservoir is
empty.
1004
Measure
• Fill the reservoir with cutting apparatus oil.
1
2
Activate/deactivate
To activate or deactivate the button lock
• Press and hold the reverse button
• Press the on/off button
• Release the on/off button and then the R button
Only use HSM special oil.
Reservoir volume: 250 ml
Press the safety element and lift up the fl ap.
The oil fi lling opening is to the right of the feed chute.
You can fi ll the oil either through the small opening
1 (take out the yellow plug) or the normal opening 2
(unscrew the red cap).
Metal detection (optional)
The document shredder can be optionally equipped
with a metal detector. The automatic switch-off al-
lows damage to the cutting unit by paper clips or
other metal objects to be avoided.
Safety element monitoring
Movement of the safety element was detected
during the shredding procedure. If your machine
switches off without signalling an error, pull the pa-
per out of the paper slit and feed it back in again.

Cleaning and maintenance

Switch off the shredder and pull out the mains plug.
When cleaning only use a soft cloth and a mild
soap-water solution. However, no water must enter
the equipment.
• Spray special cutting apparatus oil through the
paper feed opening along the entire width on to
the cutting rollers.
• Allow the cutting unit to run in permanent mode
without paper for a short period.
 Paper dust and particles are shaken off.
Strip cut only:
Oil the cutting unit when
cutting performance decreas-
es or the device becomes
noisy, or every time you empty
the waste container:
13