Installation And Lubrication; Parts And Maintenance - Ingersoll Rand 88V Serie Especificaciones Del Producto

EN
Model(s)
88V60P107M-EU
88V60P109M-EU
88V85P107M-EU
88V60S106M-EU
99V60P107M-EU
99V60P109-EU
99V60P109M-EU
99V85P107M-EU
99V45S106-EU
99V60S106-EU
99V60S106M-EU
† K = 3dB measurement uncertainty
pA
‡ K = 3dB measurement uncertainty
wA
* K = Vibration measurement uncertainty
Sound and vibration values were measured in compliance with internationally recognized
test standards. The exposure to the user in a specific tool application may vary from these
results. Therefore, on site measurements should be used to determine the hazard level in
that specific application.

Installation and Lubrication

Size air supply line to ensure tool's maximum operating pressure (PMAX) at tool inlet. Drain
condensate from valve(s) at low point(s) of piping, air filter and compressor tank daily. Install
a properly sized Safety Air Fuse upstream of hose and use an anti-whip device across any
hose coupling without internal shut-off, to prevent hose whipping if a hose fails or coupling
disconnects. See drawing 16573198 and table on page 2. Maintenance frequency is shown in a
circular arrow and defined as h=hours, d=days, and m=months of actual use. Items identified as:
1. Air filter
2. Regulator
3. Lubricator
4. Emergency shut-off valve
5. Hose diameter
6. Thread size

Parts and Maintenance

When the life of the tool has expired, it is recommended that the tool be disassembled,
degreased and parts be separated by material so that they can be recycled.
Original instructions are in English. Other languages are a translation of the original instructions.
Tool repair and maintenance should only be carried out by an authorized Service Center.
Refer all communications to the nearest Ingersoll Rand Office or Distributor.
EN-2
Sound Level dB(A)
(ISO15744)
† Pressure (L )
p
86.2
86.2
83.9
86.2
81.4
82.5
82.5
103.0
---
82.4
82.4
WARNING
‡ Power (L )
w
97.2
97.2
94.9
97.2
92.4
93.5
93.5
114.0
---
93.4
93.4
7. Coupling
8. Safety Air Fuse
9. Hose Whip
10. Oil
11. Oil (Fill Oil Chamber, if applicable.)
Vibration (m/s²)
(ISO28927)
Level *K
3.1 0.9
3.6 1.1
4.1 1.3
<2.5 ---
2.8 0.9
3.4 1.1
3.4 1.1
3.6 1.1
<2.5 ---
<2.5 ---
<2.5 ---
16573222_ed5