OHAUS STCON7 Instrucciones Generales página 5

STCON7 electrode EN-3
8. Ensure the cable connectors are free of
moisture and dirt.
9. For calibration and measurement
procedures, refer to the Instruction manual
supplied with conductivity meter.
10. In general, measurements using stirred
samples are preferred.
Storage
Rinse or clean the electrode after each use.
Then keep it in a dry can clean environment.
Precautions and Limitations
1. Do not expose the shaft to organic
solvents, when cleaning or when taking
measurements.
2. Do not use the probe outside the
recommended temperature range.
3. Please calibrate the electrode with 84
μS/cm standard solution for an accurate
measurement according to the meter
instruction manual.
4. STCON7 can work with Starter 300C and
Starter 3100C meters.