Serfas Mode; Using The Receiver Controls; Selecting Which Device The Footswitch Will Control; Unsychronizing Footswitches - Stryker iSwitch Manual De Operación Y Mantenimiento

SERFAS Mode

Decrease Cut Level
Cut
Figure 6: Default controls of the Wireless Footswitch in SERFAS Mode

Using the Receiver Controls

While the footswitch controls the devices connected to the iSwitch system, the
receiver controls how the footswitch functions. Receiver controls are used for
selecting which device the footswitch will control, unsynchronizing footswitches,
and merging footswitches.

Selecting which device the footswitch will control

Press the mode button to toggle through the connected devices. The selected
device will appear on the display screen.
Note Mode button 1 selects the devices footswitch 1 will control; mode
button 2 selects the devices footswitch 2 will control.
The device can also be selected by pressing the mode button on
Note
the footswitch.

Unsychronizing footswitches

Press and hold the mode button to disable communication between a footswitch
and the receiver. After the footswitch has been unsynchronized, the footswitch
will not function again until it is resynchronized with the receiver.

Monitoring battery life

The receiver will provide feedback to alert the user when the remaining battery
life is low. The receiver will emit an audible warning and the receiver LED will
In this event, replace the battery pack after the current case
flash red.
has finished
.
Note It is recommended to use the Stryker Battery Pack (P/N 277-300-
100).
Select Device*
(SERFAS, TPS, etc.)
Increase Cut Level
Coag
12