Troubleshooting - Stryker iSwitch Manual De Operación Y Mantenimiento

Troubleshooting

Problem
No results when the
Footswitch is pressed.
The Footswitch will not
synchronize with the
receiver.
The receiver does not
indicate that a device is
attached upon startup.
Footswitch 2 is stuck using
the same device as
Footswitch 1.
Cannot hear audio
messages.
When synching the
Footswitch, the LED on the
Receiver does not change
color and synching fails.
The Footswitch will not
synchronize with the
Receiver. An adjacent
Receiver is present.
The Receiver displays
"Replace batteries" even
though new batteries have
been inserted
Possible Solution
• Press buttons I or III to wake Footswitch.
• Synchronize the Footswitch.
• Replace batteries.
• Hold the Footswitch synchronization icon
within one inch of the receiver synchroni-
zation icon.
• Press buttons I and III simultaneously and
release.
• Replace batteries and try again.
• Ensure the device is connected to the cor-
rect input on the rear receiver panel.
• Press the mode button to unmerge the
Footswitches.
• Increase volume using control on rear of
receiver.
• If another Footswitch is already synched to
this channel, press and hold the Mode but-
ton on the Receiver for 5 seconds to clear
the existing Footswitch.
• Synch the new Footswitch.
• Press buttons I and III simultaneously and
release to disconnect the Footswitch from
the adjacent Receiver.
• Synch the Footswitch to the new Receiver.
• Batteries may be inserted incorrectly. Rein-
sert batteries.
14