Viking DrawerMicro VMOD5240 Guia De Instalacion página 4

DrawerMicro Oven Measurements
1
B
F
G
I
J
L
P
A. 6" (152.40 mm)
B. Suggested electrical outlet location*
C. Anti-Tip block
D. 5" (127 mm)
E. 3-1/2" (88.90 mm)
F. 4" (101.60 mm)
G. 22-1/8" (561.98 mm) opening
H. 14-13/16" (376.24 mm) to bottom of Anti-Tip block
I. Allow 7/8" (22.23 mm) overlap
J. 23-1/2" (596.90 mm) minimum depth
K. Allow 3/16" (4.76 mm) overlap
L. 36" (914.4 mm) countertop height
M. Allow 1/8" (3.17 mm) overlap
N. Floor must support 100 lb (45.4 kg)
O. 19" (482.60 mm) to top of floor
P. 24" (609.6 mm) cabinet minimum
Q. 15-9/16" (395.27 mm) opening
A
C
E
D
H
K
Q
I
N
M
O
2
F
A. 21-5/8" (549.28 mm)
B. 4-11/16" (119.06 mm)
C. 1-3/4" (44.45 mm)
D. 21-7/8" (555.60 mm)
E. 23-7/8" (606.43 mm)
F. 15-7/8" (403.22 mm)
G. 14-19/32" (370.69 mm)
H. 1-9/64" (29 mm) door thickness
I. 15" (381 mm) auto drawer opening
J. 4" (101.6 mm)
Figures 1 and 2 contain many DrawerMicro measure-
ments for reference when planning the drawer's location.
This DrawerMicro can be installed below any electric or
gas wall oven.
* Can also be installed using an electrical outlet in an
adjacent cabinet within the area where the provided
electrical cord can reach. Power cord access hole in
cabinet should be a minimum 1-1/2" diameter hole
and deburred of all sharp edges.
IMPORTANT - Always allow sufficient power cord
length to the electrical outlet to prevent tension.
Always check electrical codes for requirements.
E4
B
A
C
J
I
D
H
E
G