Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Drawer Installation
5
A
PARTS SUPPLIED
B
4 Screws
1. Place the drawer adjacent to the wall or cabinet open-
ing. Plug the power supply cord into the electrical
outlet.
2. Carefully guide the drawer into the prepared opening.
Avoid pinching the cord between the oven and the
wall.
3. Slide the drawer all the way until the mounting flange
is flush with the face of the cabinet. See figure 5A.
4. Open the drawer. Using the 4 holes on the drawer
as a template, pre drill the cabinet using a 1/16" bit.
See figure 5A.
5. Secure the drawer with the 4 screws supplied. See
figure 5B.
Viking Range, LLC
111 Front Street
Greenwood, Mississippi 38930 USA
(662) 455-1200
For product information, call
1-888-845-4641 or visit our web site at
vikingrange.com in the US
or brigade.ca in Canada
Model and Serial Number
Location
The name plate includes model number and serial num-
ber. Open the DrawerMicro oven fully. The label is slightly
beyond the back wall of the microwave cavity facing up
from the flat surface.
Care, Cleaning and
Maintenance
Refer to the Use and Care Manual for cleaning instruc-
tions.
Mounting Screws
Before You Call for
Service
Read the BEFORE YOU CALL and operating instruction
sections in your Use and Care Manual. It may save you
time and expense. The list includes common occurrences
that are not the result of defective workmanship or ma-
terials in this range.
Refer to the warranty in your Use and Care Manual for
toll-free service number and address. Please call or write
if you have inquiries about your microwave product and/
or need to order parts.
E6
E6
Publicidad
Tabla de contenido
