Viking DrawerMicro VMOD5240 Guia De Instalacion página 5

Anti-Tip Block
NORMAL INSTALLATION STEPS
Anti-Tip Block Installation Instructions
• To reduce the risk of tipping of the drawer, the Anti-Tip
block must be properly installed located 14-13/16"
above the floor on which the appliance will sit. The 6"
Anti-Tip block must be provided by the installer. See
figure 1 and 3. The Anti-Tip block prevents serious
injury that might result from spilled hot liquids.
• If the DrawerMicro Oven is ever moved to a different
location, the Anti-Tip block must also be moved and
installed. When installed to the wall, make sure that
the screws completely penetrate the dry wall and are
secured in wood or metal so that the block is totally
stable. When fastening, be sure that the screws do not
penetrate electrical wiring or plumbing.
Anti-Tip block
3
5" (127 mm)
4"
(101.6 mm)
6"
(152.4 mm)
3 1/2"
(89 mm)
E5
Electrical Outlet
The electrical requirements are a 120 volt 60 Hz, AC
only, 15 amp. or more protected electrical supply. It is
recommended that a separate circuit serving only this
appliance be provided.
The DrawerMicro Oven is equipped with a 3-prong
grounding plug. It must be plugged into a wall receptacle
that is properly installed and grounded. Should you only
have a 2-prong outlet, have a qualified electrician install
a correct wall receptacle.
Note: If you have any questions about the grounding or
electrical instructions, consult a qualified electrician or
service person.
* Can also be installed using an electrical outlet in an
adjacent cabinet within the area where the provided
electrical cord can reach.
Always check electrical codes for requirements.
4
Suggested electrical
outlet location*
Anti-Tip block
5" (127 mm)
4"
(101.6 mm)
(15
3
(8