Hydraulic Connections; Equipment Location; Figure 8: Appropiate Placement Of The Equipment - Astralpool ASTRAL CDP Serie Manual Técnico. Puesta En Marcha Y Funcionamiento

4.4 HYDRAULIC CONNECTIONS

Dehumidifier units equipped with hot water batteries must respect the following indications at
the time of hydraulic connecting:
•
Always respect the hydraulic connection diameters specified for each machine.
•
A full-flow shut-off valve should be installed on each of the hydraulic elements in the
equipment, so that each of these may be isolated if needed (for repairs, substitutions,
etc.) without the need to drain the circuit.
•
Anti-vibration dampers should be installed in the inlet and outlet of the machine, in order
to avoid vibrations which may cause cracks or breakage in the hydraulic connections.
•
In order to avoid possible breakage, do not force the copper tubes connected to the
water supply.
Take into account the fact that to establish the proper water flow in the hot water battery,
it has to be connected the water inlet in the upper connection and water return
connected to lower one (See Figure 1).

4.5 EQUIPMENT LOCATION

It is important that the equipment be installed on stable, horizontal ground.
Always place the equipment vertically and far away from dangers of inundation. If not, the
warranty will be voided.
Like any other electrical equipment, the dehumidifier should be installed more than 2 meters,
horizontally, away from the pool (Volume 2) and 2,5 meters, vertically, away from the pool.
© ASTRALPOOL 2008. ALL RIGHTS RESERVED. CONFIDENTIAL AND PROPRIETARY DOCUMENT.

Figure 8: Appropiate placement of the equipment.

ENGLISH
Page 51 of 69