Operation And Maintenance; Cleaning Of The Device - Tristar PO-2600 Manual De Usuario

Instruction manual

OPeRATION AND MAINTeNANCe

• Remove all packaging of the device.
• Check if the voltage of the appliance corresponds to the main voltage
of your home.
• Rated voltage : AC220-240V 50Hz. Only connect this appliance to an
earthed socket.
FIRST USe
• Clean all loose parts, these are not dishwasher safe.Clean the housing
with a damp cloth.
• Never immerse in water! At the first use the machine can spread some
smell and smoke, this is normal. Always place the machine in a well
ventilated area and on a flat and stable surface.
USe
• The popcorn maker is not a toy! Do not allow minors to opperate this
appliance.
• Children should be closely supervised by an adult when the appliance
is in use.
• The popcorn maker makes a large dish op popcorn from a handful of
corn in about 3 minutes. A small cup is provided for measuring out the
required amount of corn and for melting butter if reguired.
• Fill the measuring cup(no.1) with corn. Spread the corn around the
popcorn chamber(no.3) in the machine. Only corn is required for
making popcorn,never put other ingredients, such as oil, suger or
salt into the popcorn chamber! Lose the popcorn lid(no.2). Use a heat
4
resisted dish which will fit under the opening of the machine to catch
the popcorn as it is made. Plug in the machine and switch it on using
the On/off switch(no.5) on the side of the popcorn maker. After about
3 minutes most of the grains will have exploded and the popcorn is
ready to eat.
• Sweet popcorn can be made by shaking caster sugar over the just
made warm popcorn. Flavoury popcorn can be made by adding some
salt to the popcorn.
• If disired the measuring cup can be used to melt butter during the
process. Butter must be placed in the measuring cup before the
popcorn maker is switched on. The melted butter can be spread over
the popcorn after it is made.
• Then switch off the machine again by moving the main switch to
"off". Do not open the lid for at least 10 minutes after the machine has
stoped.
• After each use, let the machine cool down for about 10 minutes. The
popcorn maker has an overheating security device which will switch
the machine off automatically if it becomes overheated. The machine
will function normally once the temperature has dropped down to a
normal level again.

CleANING OF THe DeVICe

• First remove the plug from the wall-outlet and allow all the parts to
cool down before cleaning them. Clean the popcorn maker after each
use to prefent leftover food from sticking. Do not use abrasive or
strong detergents. Never immerce the device in water or other liquid.
The device and the accessories are not dishwasher save.
• The outside can be wiped with a damp cloth.