Replacing Battery; Changing The Contact Points; Collar Adjustment - EYENIMAL STATIC NOBARK COLLAR Manual De Instrucciones

• Replacing battery

EYENIMAL advises to use the same type and same brand of batteries as those supplied in your new purchased
product. Other brands of batteries may not operate, or may not be completely compatible with your product.
You can purchase the suitable batteries from EYENIMAL or from your distributor.
Replace the battery as follows:
aUnscrew the battery cover using a coin.
aRemove the old battery.
aInsert the new battery (Lithium 3-V CR2) paying attention to follow polarity indicated on the collar (ref. Diagram 1).
aRetighten the battery cover using a coin. A beep sound is emitted indicating the collar is ready for use. If you do not
hear any beep sound when retightening the battery cover, remove the battery immediately from its housing. Check
the polarity before trying again.
NOTE: when changing the battery, there can remain some power in your collar. In that case, the collar does not emit any
beep sound when you retighten the battery cover after inserting the battery. To make sure it operates properly and that
the battery is correctly installed, see. Checking the device operates properly.
Due to greater use during your dog's training, the first battery may not last as long as replacement batteries.

• Changing the contact points

Two different series of contact points are supplied. The length of the contact points must be sufficient to have proper
contact with the dog's skin, enabling the device to operate correctly (proper barking detection and correct transmission of the static corrections).
If you have a long-haired dog and the short contact points fitted to the collar in the factory are inadequate, remove and
replace them with the long ones supplied with the kit.
Carefully tighten them manually (do not use a key).
• Checking the device operates correctly
You can check that your collar is functioning properly at any time using the following procedure:
aBefore doing so, make sure the collar is turned off (battery removed from its housing).
aFix each wire of the neon test lamp under each contact points (unscrewing them lightly and retightening them so as to pinch the test
lamp wires under the contact points).
aTurn On the collar (warning: after activating the collar, it remains in stand-by for 30 seconds).
aMake a streaked object (ex. knife with teeth and isolated sleeve) slide on the bark detection contact point (ref. Diagram 1).
aThe collar should emit beep sounds and the test lamp should light.
aBefore disconnecting the test lamp, make sure the collar is turned off (battery removed from its housing).

• Collar adjustment

Collar adjustment is very important. In fact, this setting determines the proper barking detection and the correct
transmission of the static corrections.
The strap should be adjusted so that the contact points come right into contact with the dog's skin:
aIf the strap is too loose, the collar will not operate properly. Moreover, the collar is likely to move and repeated friction
can irritate your dog's skin.
aIf the strap is too tight, the dog will have breathing difficulties.
The strap is properly adjusted when you can insert two fingers between the strap and your dog's neck.
If necessary, replace the short contact points with the long ones supplied with the kit (ref. § Changing the contact points).
4
UIDE STATIC NOBARK COLLAR indice B.indd 4 UIDE STATIC NOBARK COLLAR indice B.indd 4 03/04/2020 15:0 03/04/2020 15:0