Cleaning And Maintenance - HSM 450.2 Instrucciones De Servicio

6 Cleaning and maintenance

Switch off the shredder and pull out the mains
plug. When cleaning only use a soft cloth and
a mild soap-water solution. However, no water
must enter the equipment.
Oil the cutting unit when
cutting performance de-
creases or the device be-
comes noisy, or every time
you empty the waste con-
tainer:
8 Technical data
US-Version
Cutting type
Shred size (mm)
Nominal cutting ca pa ci ty, DIN A4
Cutting speed
Lo ading width
Power supply
Rated power
Nominal current
Plug
Ambient air temperature
Dimensions W x D x H (mm)
Weight
Volume of shredded material bag
Noise level (Idle running/ load)
EU-Version
Cutting type
Shred size (mm)
Sa fe ty ra ting DIN 32757 – 1
Cutting ca pa ci ty (sheets), DIN A4
Cutting speed
Lo ading width
Power supply
Power for the maximum number of sheets
Power supply fuses
Dimensions W x D x H (mm)
Weight
Volume of shredded material bag
Noise level (Idle running/ load)
0807
70 g/m 2
70 g/m
2
80 g/m 2
HSM 450.2
• Spray special cutting block oil
through paper feed opening across
the whole width of the cutting system
blades.
• Run cutting system forwards and
backwards several times without
feeding paper.
Paper dust and particles are shaken
off.
Cross cut
3.9 x 50
60 sheets
218 mm/s
443 mm
3W + PE 208 V, 60 Hz
2.99 HP
20 A
L15-30P 30 A
25 °C
750 x 665 x 1590
220 kg
290 l
58 dB(A) / 70-75 dB(A)
Cross cut
3.9 x 50
3
80 - 85
65 - 70
218 mm/s
443 mm
3 x 400 V, 50 Hz
3 kW
3 x 16 A (slow-blow)
750 x 665 x 1590
220 kg
290 l
58 dB(A) / 70-75 dB(A)
13