Maintenance And Cleaning; Cleaning The Unit - Oase LunaLED Set 1 Instrucciones De Uso

- English -

Maintenance and cleaning

Attention! Dangerous electrical voltage.
Possible consequences: Death or serious injuries.
Protective measures:
• Prior to reaching into the water, disconnect the power supply to all units used in the water.
• Disconnect the power plug prior to carrying out work on the unit.
Note:
● Ensure that no moisture can enter the unit.

Cleaning the unit

● Cleaning should only be done with warm soapy water. Be sure to use biodegradable soap.
● The frequency of cleaning depends upon the conditions of the environment where lights are used.
Storage/Winterization
● Put the unit out of operation at water temperatures below 46 °F (8 °C) or, at the latest, when freezing temperatures are
to be expected.
● Thoroughly clean the unit, check for damage.
● Ensure that the storage place is inaccessible to children.
Disposal
Do not dispose of this unit with domestic waste! Disable the unit beforehand by cutting off the cables. Further
information about the recycling of this product can be obtained from your local municipal authority.
Troubleshooting
Issue
Lamp does not light up
Light intensity decreases
Water in the spotlight
housing
Cause
Power supply interrupted
Sensor is blocked
Lamp lens soiled
Seal defective
Solution
Check power supply
Check sensor. Make sure the sensor faces up and is not
covered by dirt or debris.
Clean
Check sealing rings and replace, if necessary
6