Stihl FS 85 Manual De Instrucciones página 68

English
13 12
13
13
Position the throttle cable
N
retainer (13) and throttle cable (12)
against the drive tube.
Close the throttle cable
N
retainer (13). The retainer (13)
snaps into place.
Adjusting the Throttle Cable
Check adjustment of throttle cable –
N
see chapter on "Adjusting the
Throttle Cable".
Mounting Bike Handle with Swiveling
Handle Support
The machine is supplied with the
swiveling handle support already
mounted on the shaft. To mount the
handlebar it is necessary to remove the
clamp moldings.
66
Removing the Clamp Moldings
12
Hold the lower clamp (1) and upper
N
clamp (2) firmly together.
Release the wing screw (3) – the
N
clamps are loose once the wing
screw has been released. They are
pushed apart by the two
springs (4 and 5).
Pull out the wing screw – the
N
washer (6) remains on the wing
screw.
Separate the clamp moldings – the
N
springs (4 and 5) remain in the
lower clamp.
Securing the Handlebar
7
Place the handlebar (7) in the lower
N
clamp (1) so that distance A is no
more than 15 cm (6 in).
Place the upper clamp in position
N
and hold both clamp moldings
together.
Push the wing screw through the
N
two clamps as far as stop – hold all
parts together and secure them.
FS 85, FS 85 R
A
1