Adjusting The Throttle Cable - Stihl FS 85 Manual De Instrucciones

Ocultar thumbs Ver también para FS 85:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Mounting the Loop Handle without
Barrier Bar
7
7
8
8
4
3
5
6
1
1
Place the clamp (3) in the loop
N
handle (4) and position them both
against the drive tube (5).
Position the clamp (6) against the
N
drive tube.
Line up the holes.
N
Fit washers (8) on the screws (7)
N
and insert the screws in the holes.
Fit the square nuts (1) and screw
them down as far as stop.
Go to "Securing the Loop Handle".
N
FS 85, FS 85 R
Securing the Loop Handle
A
9
The loop handle can be adjusted to suit
the height and reach of the operator and
the application by changing
distance (A).
Recommendation: distance (A):
about 20 cm (8 in)
Slide the handle to the required
N
position.
Line up the loop handle (4).
N
Tighten down the screws until the
N
loop handle can no longer be
rotated on the drive tube. If no
barrier bar is fitted – lock the nuts if
necessary.
The sleeve (9) (not fitted on all models)
must be between the loop handle and
the control handle.

Adjusting the Throttle Cable

A properly adjusted throttle cable is the
precondition for correct operation in the
full throttle, starting throttle and idle
positions.
Adjust the throttle cable only after the
unit is fully assembled – the control
handle must be in the normal operating
position.
4
Use a suitable tool to push the slide
N
to the end of the slot (see
illustration).
Press down the throttle trigger
N
lockout (1) and squeeze the throttle
trigger (2) (full throttle) – this sets
the throttle cable correctly.
English
2
1
69

Publicidad

Capítulos

Tabla de contenido
loading

Este manual también es adecuado para:

Fs 85 r

Tabla de contenido