Charging Batteries - Bosch LW 20/30 E Instrucciones De Servicio

10. Rating plate
11. Mains fuse holder
with replacement fuse
(slow-blow 4 A)
12. Mains connection for inlet con-
nector for non-heating appara-
tus (230/240 V, 50 Hz)
13. Charging leads
Positive (+) = Red
Negative (–) = Black
14. Holder for charging leads and
storage holder for operating
instructions
English
Installation
F The charger must be set up
horizontally on a firm surface.
The location (e.g. shelf) must be
sufficiently stable.
Pay attention to unit weight.
F Do not cover the charger.
Set up the charger so that there
is a clearance of at least 15 cm
on all sides for ventilation purpo-
ses.
F Protect the charger against
moisture.
F The charger must only be
connected to a mains power
supply where the mains vol-
tage agrees with the voltage
rating on the rating plate (10).

Charging batteries

F Set
the voltage
switch (9) to "0" (OFF) before
connecting the charger to the
mains supply!
F Before charging the instruc-
tions of the battery manufac-
turer must be read and then
followed.
F Wear protective goggles.
F Immediately wash off acid
splashes on the skin or clo-
thing with large quantities of
water. If necessary consult a
doctor.
F Charge only fault-free batte-
ries with a rated voltage of
12 V or 24 V.
F Only tested batteries must be
connected in parallel for char-
ging.
F Maintenance-free
must not be charged together
with standard batteries.
11
selector
batteries