Troubleshooting Guide - Faro Barcelona GALÁPAGO Manual De Usuario

INSTRUCCIONES DE SEGURIDAD / INSTRUCTION DE SÉCURITÉ / SAFETY INSTRUCTIONS / INSTRUÇÕES DE SEGURANÇA / SICHERHEITSHINWEISE /
VEILIGHEIDSINSTURCTIES / INSTRUZIONI DI SICUREZZA / ΟΔΗΓΊΕΣ ΑΣΦΑΛΕΊΑΣ / ИНСТРУКЦИИ ПО ТЕХНИКЕ БЕЗОПАСНОСТИ
INSTALLING LIGHT KIT
GREEN/YELLOW
GREEN/YELLOW
1. Fit the light kit to switch housing with 3 secure screws.
2. The light kit is switched on and off by the use of the pull chain on the side of switch housing.
3. insert 3 GU10x50Watts lamp (provided) into the lampholder . do not use high watt lamp.
OPERATION & MAINTENANCE
Maintenance
1. As fans tend to move during operation, some connections may loosen. Check the supporting screws, brackets and
blade attachments twice a year to ensure that they are secure.
2. Cleaning the fan helps to maintain its appearance for years. Do not use water when cleaning. This could damage
the motor or the blades and could cause electrocution.
3. Use a soft brush or lint-free cloth to prevent scratching the surface.
4. There is no need to oil the motor as the bearings are permanently lubricat.
TROUBLE-SHOOTING GUIDE
The fan does not start:
1. Check the fuses and circuit breakers.
2. Review the connections of the terminal block according to the indications in the installation.
3. Ensure the power is off before doing this.
Make sure that the sliding switch is firmly in the position of up or down. The ventilator does not work when the button is in the
middle.
4. Make sure that the stabilizing tongue-pieces of the motor are off.
5. Finally if the fan will not start call an electrician do not attempt to touch the internal parts.
galápago ref. 33301, 33302
SWICHT HOUSING
RED
BLUE
RED
BLUE
faro 16