Working With Your Machine - Viking GB 460 Manual De Instrucciones

Observe the local regulations regarding
permitted operating times for gardening
power tools with combustion engines or
electric motors.
Check the fuel system (particularly visible
parts such as e.g. tank, tank cap, hose
connections) before operating the
machine. In the event of any leaks or
damage, do not start the engine – fire
hazard!
Have the machine repaired by a specialist
dealer prior to operation.
Defective and all other worn or damaged
parts must be removed before using the
machine. Replace any illegible or
damaged danger signs and warnings on
the machine. Your VIKING specialist has a
supply of replacement stickers and all the
other spare parts.
Before initial operation, it must be ensured
– that the covers and guards are in place
and in good condition
– that all fuel-carrying components are
fitted to the engine and are in good
condition (leak-tight)
– that the tank is in good condition (leak-
tight)
– that the housing and cutting tools
(blades, blade shaft, blade discs, etc.)
are not worn or damaged
– that there is no shredding material in
the machine and that the feed chute is
empty
– that all screws, bolts, nuts and other
fastening elements are in place and
properly tightened. Tighten any loose
screws, bolts and nuts prior to initial
operation (observe tightening torques).
0478 216 9905 D - EN
Only use the machine out-of-doors and not
close to walls or any other solid objects in
order to prevent the risk of injuries and
property damage (no escape for the user,
broken windows, scratched cars etc.).
The machine must placed in a stable
position on firm and level ground.
Do not use the machine on a paved or
gravel-covered surfaces, as ejected or
thrown-up material could cause injuries.
Before using the machine, always check
that it is properly closed. (
Make sure that you are familiar with the
On / Off switch so that you can react
quickly and correctly in any emergency
situation.
When the garden shredder is in the
working position, the feed opening must
always be completely covered by the
splash guard. If this is not the case, the
splash guard must be replaced.
Risk of injury:
Only operate the machine when properly
assembled. If parts of the machine
(e.g. wheels, feet etc.), are missing, the
specified safety distances are no longer
maintained and the stability of the machine
may also be reduced.
Before using the machine, always carry
out a visual check to ensure that it is in
good operating condition.
"Good operating condition" means that the
machine is fully assembled, in particular:
– Upper chute is installed on lower chute
– Branch guide is installed
– Feed chute is installed on the basic
machine
– Wheel carrier assembly is installed
– Both wheels are mounted and the tyre
pressure complies with the
specifications contained in this
instruction manual (
– All safety devices (ejection chute,
splash guard etc.) must be present and
functional
– Both cutting units (blade discs) are
installed
– All blades are properly installed
The switch and safety devices installed in
7.5)
the machine must not be removed or
bypassed.
Visually inspect both blade discs for
damage and deformation; replace if
necessary.

4.6 Working with your machine

Do not operate the machine in the rain or
during thunder storms, particularly when
there is a risk of lightning strike.
The risk of accidents is higher if the ground
is damp due to increased danger of
slipping.
Particular caution should be exercised
during working in order to prevent slipping.
If possible, avoid using the machine when
the ground is damp.
Only work during the day or with good
artificial light.
Keep the working area neat and tidy at all
times. Remove tripping hazards such as
stones, branches, cables etc.
The operator should not stand any higher
than the level of the base of the machine.
12.12)
Never work when animals or
persons, particularly children,
are in the danger area.
51