Sony CMT-A50 Manual De Instrucciones página 39

Setting up the AM loop aerials
3
Connecting the mains lead
1 Connect the mains lead from the left
speaker to the SPEAKER OUT
(POWER IN) socket located at the
rear of the player.
2 Insert the end of the mains lead from
the left speaker to the mains.
Note
If you disconnect the mains lead or a blackout has
occurred, the clock setting and other preset
settings may return to the initial settings. In this
case you need to reset the clock and/or other
preset settings.
Changing the AM tuning interval
The AM tuning interval is preset to
9 kHz at the factory.
If you need to change the AM tuning
interval, do the following:
1 Press TUNER BAND•AUTO PRESET
until "AM" is displayed.
2 Press the jog dial for 2 seconds.
3 Press TUNER BAND•AUTO PRESET
for 2 seconds.
"AM 9kHz" or "AM 10kHz" flashes.
4 Press ./m or M/> to select
"AM 9kHz" for 9 kHz interval or "AM
10kHz" for 10 kHz interval.
5 Press the jog dial to enter the selection.
After changing the tuning interval, you need
to reset your preset AM radio stations.
4
Inserting batteries into the remote
Insert two R03 (size AAA) batteries
(not supplied).
Replacing batteries
With normal use, the batteries should last for
about six months. When the remote no
longer operates the player, replace all the
batteries with new ones.
GB
39