Safety Notes - Hansgrohe Raindance Connect Showerpipe 27164000 Instrucciones De Montaje

Safety Notes

• Gloves should be worn during installation to prevent
crushing and cutting injuries.
• The arm of the shower head is intended only to hold
the shower head. Do not load it down with other
objects!
• The product may not be used as a holding handle. A
separate handle must be installed.
• The shower system may only be used for bathing,
hygienic and body cleansing purposes.
• Children as well as adults with physical, mental
and/or sensoric impairments must not use this shower
system without proper supervision. Persons under
the influence of alcohol or drugs are prohibited from
using this shower system.Do not allow the streams of
the shower touch sensitive body parts (such as your
eyes). An adequate distance must be kept between
the shower and you.
Assembly (see page 36)
Important! The fitting must be installed, flushed and
tested after the valid norms!
Important! Do not use silicone containing acetic acid!
• Where the contractor mounts the product, he should
ensure that the entire area of the wall to which the
mounting plate is to be fitted, is flat (no projecting
joints or tiles sticking out), that the structure of the wall
is suitable for the installation of the product and has
no weak points. The enclosed screws and dowels are
only suitable for concrete. For another wall cons-
tructions the manufacturer's indications of the dowel
manufacturer have to be taken into account.
• If required, the bottom part of the pipe between the
fixture and the shower head can be shortened with a
fine-toothed saw.
• The mesh washer must be insert to protect the
overhead shower against incoming dirt by pipework.
Incoming dirt leads to defects or/and can damage
parts of the shower; such caused faults voids all liabili-
ty and guarantee claims.
Assembly corner fitting set (see page 39)
Adjustment (see page 43)
4
English
Technical Data (see page 31)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Operation (see page 44)
Spare parts (see page 35)
Cleaning (see page 45)
max. 1 MPa
0,2 - 0,5 MPa
1,6 MPa