Selecting Language; Updating Analyzer; Testing Cordless Power Tool - Stihl ADG 2 Manual De Instrucciones

Selecting Language

Connect the analyzer to the power
N
supply – mains voltage and
operating voltage of the analyzer
must be the same – see
"Connecting Analyzer to Power
Supply".
Wait for analyzer to run self test –
N
there is no need to insert a battery in
the analyzer to select a language.
Press the lower button on the
N
analyzer – see "Main Parts" – for
about 3 seconds to activate
language selection.
Select required language by briefly
N
pressing the upper or lower button.
To confirm the language selected,
N
press and hold down the lower
button on the analyzer for about 3
seconds.
The language can be changed at any
time.
ADG 2

Updating Analyzer

The analyzer must be updated to cover
the latest cordless power tools or new
batteries and additional diagnostic
functions. The update can be performed
as described below.
Direct update with diagnostic software
and internet access
Computer with diagnostic software has
access to internet – see "Diagnostic
Software":
Connect analyzer to the computer
N
with the USB cable.
In the menu, click on button "Check for
updates... ". The diagnostic software
checks whether an update is available. If
yes, the update is performed
automatically.
Indirect update (without computer)
If no computer is available, contact the
sales subsidiary.

Testing Cordless Power Tool

Connect the analyzer to the power
N
supply – see "Connecting Analyzer
to Power Supply".
Operate the analyzer indoors only in dry
locations at an ambient temperature
between +5°C and +40°C.
Operating instructions
The analyzer is operated with two
pushbuttons (1):
To confirm procedures during test
–
To scroll between display pages
–
during test
To select language
–
To clear the fault memory
–
Fitting the Battery
A suitable original STIHL battery with a
minimum charge of 80% is required to
test the cordless power tool. The battery
supplies the cordless power tool with the
power needed for the test.
English
1
19