Connecting Analyzer To Computer; Updating Diagnostic Software - Stihl ADG 2 Manual De Instrucciones

Connecting Analyzer to
Computer
Connect the analyzer to the computer
only after installing the STIHL diagnostic
software.
A USB cable is used to connect the
analyzer to the computer. The USB
cable is included with the analyzer.
Connect analyzer to the computer
N
with the USB cable.
The operating system installs the drivers
automatically – providing the function
has not been deactivated. Otherwise the
driver has to be installed manually and
the hardware assistent appears.
Check – "No, not this time" – click
N
"Next".
Check – "Install software from a list
N
or other source" – click "Next".
Check – "Also search following
N
source" – click "Search".
The following directory must be selected
for drivers: Installation
Directory\STIHL\SDS\Driver\ADG2\
Select installation directory, e.g.
N
® ®
Microsoft Windows XP Standard
Installation Directory: C:\Program
Files\STIHL\SDS\Driver\ADG2\ –
click "OK"
Driver is installed. Exit assistant with
N
"Finish".
Restart the computer.
N
Start STIHL diagnostic software.
N
The status bar shows
ADG 2 connected
ADG 2
Clicking on "ADG 2" graphic
N
changes view on screen to
"Initializing".
Now follow the operating
N
instructons for the STIHL diagnostic
software – observe safety
precautions in STIHL diagnostic
software during operation.
Updating Diagnostic
Software
The introduction of new power tools and
additions to diagnostic functions
necessitate a software update. The
update can be performed as described
below.
Direct update via internet
Computer with diagnostic software has
access to internet:
In the menu, click on button "Check for
updates... ". The diagnostic software
checks whether an update is available. If
yes, the update is performed
automatically.
Indirect update (without internet access)
Computer with diagnostic software does
not have access to internet:
Data for updating the diagnostic
software is supplied by the subsidiary.
English
25