Operation; Application Area - Silvercrest SSDMD 600 A1 Instrucciones De Servicio

the blender jug 4 back on the motor
block 7.
1. Unwind the required length of power
cable 10 from the cable spool 11.
2. Figure B: place the blender jug 4 on
the motor block 7. The arrow
point to the
the blender jug. Fill the prepared food
into the blender jug 4.
3. Figure B: close the blender jug 4 with
the lid 2.
4. Figure B: turn the lid 2 fully into the
handle 5 in order to firmly connect it to
the blender jug and close the safety de-
vice 3.
5. If necessary, turn the marker stripe of
the control dial 9 to 0.
6. Insert the measuring jug 1 into the
lid 2 and lock it by turning it clockwise.
7. Figure B: lock the blender jug 4 by
rotating through a short distance. The
arrow at the bottom of the blender
jug points to the
the second safety device 8.
8. Insert the mains plug 10 into a wall
socket corresponding to the technical
data.
must
symbol at the bottom of
symbol. This closes

7. Operation

WARNING!
In order to avoid damage to the device,
interrupt the blending process immedi-
ately if the blades of the blade assem-
bly 6 do not turn at all or only with
difficulty. If this happens, pull out the
mains plug 10 and check whether there
is something in the blender jug 4 block-
ing movement or whether the food is too
tough. Also check whether the device is
assembled correctly.
The device is designed for a maximum
operating period of 3 minutes without
interruption.
After this, the device must remain
switched off until it has cooled down to
room
temperature.
CAUTION:
Depending on the hardness and consist-
ency of the food, do not fill the blender
jug 4 up to the maximum level, as this
can cause the blade assembly 6 to be-
come blocked.

Application area

The jug blender is designed to mix whole-
fruit beverages (smoothies) and to chop
food and crush ice.
21
GB