Troubleshooting - Ibiza sound FREESOUND40-BK Manual De Instrucciones

Frequency range ................................................................................................ 80HZ-20KHZ
S/N Ratio ....................................................................................................................... 70DB
Sensitivity ................................................................................................................... 500mV
Impedance ............................................................................................................... 10kOhm
Input Voltage .......................................................................... 9Vdc 1A via supplied adaptor
Weight ........................................................................................................................ 1,77kg
Dimensions ................................................................................................... 25 x 9 x 23,5cm
Trouble shooting
If a problem occurs, follow the steps in the table below. If problem still can't be solved, please contact your
retailer.
Problem
No sound when power on
Sound distortion
No sound from the microphone
No sound after inserting
USB/TF card
Red charging led flashes when
the charge is low
Unable to charge or the battery
works only for a short time
If Speaker makes loud noises
Electric products must not be put into household waste. Please bring them to a recycling centre. Ask your local
authorities or your dealer about the way to proceed.
©Copyright LOTRONIC 2016
Possible cause
1. No input source
2. Volume down
1. Volume too high
2. Audio file error
1. Bad mic connection
2. Mic not switched on
3. Mic volume down
1. Incorrect file format
2. Bad connection of USB/TF
card
Charging adaptor not inserted
properly
1. Adapter may not be plugged
in properly
2. Battery not fully charge
3. Battery life may have ended
1. Microphone switched on but
may be too close to the speaker
2. Microphone switched on but
is not being used.
3. Microphone volume may be
too loud
4. Mobile phone is being used
too close to the speaker
5. Other wireless equipment
may be placed very close to the
speaker.
FREESOUND40
Solution
1. Connect an AUX signal
2. Adjust volume
1. Reduce volume
2. Check and change audio file
1. Plug in the mic properly
2. Switch mic on
3. Increase mic volume
1. File format should be MP3
2. Plug in USB/TF card properly
It will not affect the speaker
system. The light is only used
for indication whether the unit
is charging.
1.Properly plug the adapter
2. Extend charging time;
normally it takes 6-8 hour to
fully charge
3. Replace old batteries with
the same specification as the
old batteries.
1. Keep the microphone 2
meters away from the speaker
2. Turn off microphone if not in
use.
3. Adjust microphone
volume to lower mode
4. Keep mobile away from the
speaker whilst attending a call.
5. Keep the speaker away from
other wireless equipment
5