Cleaning; Engine Oil Change - Zipper Maschinen ZI-STE3000IV Instrucciones De Servicio

12.2

Cleaning

 We recommend cleaning the machine immediately after each use.
 Keep all safety devices, air vents and the motor housing free of dirt and dust as far as possible
 Wipe the equipment with a moist cloth and some soft soap or blow it with compressed air at low
pressure.
Do not use cleaning agents or solvents; these could attack the plastic parts of the machine!
12.3

Engine oil change

Drain the used oil quickly and completely while the engine is still warm.
For the purposes of environmental protection fill the oil in tight containers and dispose
 Loosen the engine oil drain access cover screw and remove
the cover
 Pull out the drain hose
 Open the drain valve (position parallel to the pipe)
 Remove the drain bolt on the end of the hose
 Drain the dirty oil into a suitable container
 Close the drain valve and replace the drain bolt
 Replace the hose in the oil drain access compartment
 Reinstall the oil drain access cover and tighten the screws
securely
 Loosen the engine oil filler cover screw and remove the
cover
 Remove the dipstick
 Fill in new engine oil (15W40, 520ml) and check the engine
oil level with the dipstick
 If the level is correct (FULL) reinsert the dipstick
 Reinstall the oil filler cover and tighten the screws securely
 Remove oil residues with a rag
 Put the machine on an even area and start the engine. If
there is sufficient oil level the low oil alarm light will be not
activated
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STE3000IV
Switch off the machine before starting the engine oil change!
the oil in a recycling center. Do not dispose it with household waste
NOTICE
ATTENTION
MAINTENANCE
25