Zipper Maschinen ZI-STE3000IV Instrucciones De Servicio página 27

13 TROUBLE SHOOTING
Trouble
Engine does not start
Engine starts and is stalled
immediately
Machine works with
interruptions
Low oil light glows
Low oil light glows
Overload indicator light glows
Overload indicator light glows
Overload indicator light glows
Overload indicator light glows
Should you in necessary repairs not able to properly to perform or you have
not the prescribed training for it always attract a workshop to fix the
problem.
ZIPPER MASCHINEN GmbH www.Zipper-Maschinen.at
ZI-STE3000IV
Possible cause
 Incorrect starting sequence
 Dirty air cleaner
 No fuel supply
 Fault in the fuel line
 Engine flooded.
 Spark plug connector not placed on.
 No ignition spark
 Fuel cock closed
 Engine oil to few
 Incorrect idle adjustment
 Carburetor incorrectly adjusted
 Spark plug fouled
 Check oil level
 To less or no oil
 Low voltage protection activated
 High temperature protection
activated
 Overload protection activated
 Short circuit protection activated
NOTICE
TROUBLE SHOOTING
Solution
 Observe the correct starting
sequence
 Clean/replace air cleaner
 Refuel
 Check the fuel line for kinks
or damages
 Screw off, clean and dry the
spark plug. Then pull the
cranking rope several times
and reinstall the spark plug
 Place on the spark plug
connector
 Clean/replace spark plug
 Check ignition cable
 Open fuel cock
 Check engine oil
 Contact customer service
 Contact customer service
 Clean/replace spark plug
 Check spark plug connector
 Fill engine oil
 Fill engine oil
 Engine speed to low
 Cool down the engine
 To big loads
 Check loads
27